好消息,2920系列最新的韌體release了。
這個版號是3.6.0,正式的支援IPv6。
小弟稍後會詳細的分享各個功能,敬請期待!(如果家裡的小baby配合的話)


New Features(新功能)
Support IPv6.
支援IPv6
Support Smart Bandwidth Limit.
支援智慧型頻寬監控
Support DNS setting for each LAN subnet.
支援對個別區網設定DNS
Support LAN wired 802.1x.
支援區網802.1x認證功能
Support QoS retag.
支援QoS封包重新標籤功能

Improvement(功能加強)
Corrected: Static route doesn't work when multi-subnet is enabled.
Corrected: LAN1 will be displayed always while setting any static route for LAN2/3/4.
Corrected: Routing table display error in Diagnostic>>Routing Table page.
Corrected: Wrong LAN interface for static ARP is displayed.
Corrected: Both computers with the same VLAN cannot communicate for each other
when connecting to different switch.
Corrected: IGMP snooping problem.
Corrected: Can not open the Switch P2260 web configurator via External Device.
Corrected: The wireless client can't access internal network from another AP and return to Vigor2920 wireless LAN.
Corrected: DNS function does a force update even though no WAN IP changed.
Corrected: DHCP Relay via VPN tunnel can not work.
Corrected: Remove the incorrect log of PPP start (XXX), for we don't know who the incoming client is before authenticated by CHAP/PAP.
Corrected: IP Phones behind Vigor2920 cannot get registration after WAN Failover (Router sent UDP packets with source port 0).
Corrected: Cannot apply AES 192 and AES 256 on IPSec Security Method while the
customer chooses options of AES without Authentication in VPN and Remote Access
>> LAN to LAN page.
Corrected: Firewall can't block internal routing subnet packets.
Corrected: UCF Syslog cannot show HTTP or HTTPS.
Corrected: Can not show the FTP file list when Android phone connecting to Vigor2920 FTP server.
Corrected: ISDN Internet connection cannot work with miniVigor128.
Improved: Remove Ultrasurf from WUI.
Improved: Modify UCF/WCF block web page.
Improved: Support IP Route subnet parameters setting for TR-069.
Improved: Support firewall parameters setting for TR-069.
Improved: Support RADIUS parameters setting for TR-069.
Improved: Support Maintenance >> SysLog / Mail Alert Setup parameters setting for TR-069.
Improved: Modify the default pool size of LAN DHCP server from 50 to 150.
Improved: Online Status shows error Secondary DNS value.
Improved: Improve VPN Profile WUI.
Improved: Improve Samba with MacOS X.
Improved: Modify the Telnet command of "ip arp accept <0/1/2/3/status>" to allow the ARP REPLY which Target's MAC address does not equal to Ethernet source MAC address.
Improved: Enhance VoIP QoS.
Improved: Add new DDNS provider (UBDdns, Oray, and Peanut Shell).
Improved: Support modems such as ZTE K3806, and MF192, and MF190J, QT-R220,
LG VL600 LTE, LTE Yota LU150.
Improved: Add a telnet command for VPN packets going through by NAT or not when
VPN disconnects.
vpn pass2nat <on/off>
你好,請問有載點嗎?我在台灣居易找不到,美國居易要下載又會轉會台灣!
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!
找到了,下載中^^來去研究一下ipv6!
聽說設定以後youtube會比較順!
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!
derliang wrote:
補充一下檔案的連結:...(恕刪)


升級至 3.6.0 firmware 後, Vigor 2020n 這二天連續發生死機的問題, 不管從內網及外網都無法連線進入, Internet 都是斷線的狀態, 只能再重啟電源. 這種情況真的很少見, 在更新前使用 3.6.0RC firmware 都還不曾發生, 只能再觀察看看.
FB: Pctine

pctine wrote:
升級至 3.6.0 ...(恕刪)


我是設定排程每天凌晨四點重新開機,穩定度倒還好。
但我有發現有時PPPoE與PPP會斷線重連,所以出現連線時間比開機時間短的現象。
這台好像已經有點老態了
irsjx2vxo3ne3k84dr1dz4,r4pe8bez3/4ne3bq4bew2j92gea jx4hq me-2d8 e3hy4hi2ty k84!

derliang wrote:
我是設定排程每天凌晨...(恕刪)


我都忘了這台有排程自動重新開機的功能. 至於你提到的 NAT throughput & QoS 的問題, 因為我自家用沒有啟用 QoS & session control, 所以感覺使用上也還 ok.
FB: Pctine
文章分享
評分
評分
複製連結

今日熱門文章 網友點擊推薦!