個人積分：81分
文章編號：95701
did you apply the method i gave you? did it work on your handset? if you konw how to deal with alternative input method ie chinese input, please also tell me
there is a software that i have installed on my a920. That software can input chinese with roman keypad. ie there is not such ㄅ ㄆㄇㄈvirtul keypad. Also the input method is not quite good because you have to produce all the words you need and copy them. and then paste it whatever u are applying for. So kind of takes time. but as far as i know there is the only way now.
of course, u can install directly p800chinese package on your handset. but the problem is u won;t be able to get into control pannel\text to change the alternative method. I think this is because the original input method is stored under Z: (ROM) which is not allow you to change anything.
So here i would like to give some of my experiences and hope anyone who can fix this problem. please post your experiences on.
Also please give me a email if you have successfully installed any chinese software..
Thanks
my email is miliu8@hotmail.com
個人積分：54分
文章編號：99080
個人積分：17分
文章編號：100323
1. 手機會發出電磁波, 即使頻帶不同(GSM=900/1800, GPS=1500),
近距離下也會干擾, 同一手機的通話過程可以用echo cancel消除原發射訊號,
但是GPS並無echo cancel的設計, 所以GSM訊號發射時應該會干擾GPS.
有使用過PDA裝GPS的就知道, 即使PDA沒有手機功能, 仍然會干擾GPS模組.
2. GPS模組消耗功率功率很大, 一般使用GPS的手持裝置, 電池耗電量都很大,
撐不到幾個小時. 如果A920 [內建GPS], 手機應該撐不了多久.
3. GPS接收器大多使用 broadband patch antenna, 需要有一小塊電路板
大概3cm見方左右, 上面不可以佈任何電子零件, 只能當天線用. 如果內建,
手機體積應該也不小.
我想最好等有人實際使用過他的GPS再下評斷.
個人積分：0分
文章編號：100405
個人積分：0分
文章編號：100410
個人積分：81分
文章編號：101668
firstly i read those references from aussie3g website
and the following are the steps how i did it.
1. ensure u have upgraded ur phone urself or thru motorola repair centre.
2. install the jar app/games
3. if u see nothing happened then it means the path is not correct.
4. use jtext this software to view the txt file installed under c:/system/app/[213312f4]/[132134r4].txt--------->say example la
5 or view this txt file by transferring to computer
6. u will see on notepad says c:/system/MIDLets/temp.jar-----> that's the excute path.
7. so just change the file name u have installed to temp.jar
8. start the program and it should be working
example, u installed a program called A, and u will be able to find A.jar under c:\system\MIDLets\[12314d4]\A.jar. just just A.jar to temp.jar then everthing should be fine..
個人積分：0分
文章編號：116210
個人積分：110分
文章編號：124427
個人積分：0分
文章編號：133655
個人積分：0分
文章編號：133925
