SEAGATE 7200.11 硬碟DIY解鎖教學 (解決BIOS抓不到硬碟)

popotan · 2009-05-17T20:28:25+08:00

SEAGATE 7200.11 硬碟DIY解鎖教學剛剛靠著網路上大家的幫忙對照著教學文章把SEAGATE的硬碟給解鎖了過程都有拍照與紀錄現在把經驗分享給大家===============================事前準備工具1.不導電的塑膠套(plastic card)2.T6規格的六角螺絲起子 ( mini Torx 6 screw driver )3.已經製作好的USB解鎖線(請參閱下面Step 0, DIY it with step 0.)==============================這次的 seagate 7200.11 韌體錯誤有兩種a. BIOS抓的到硬碟,但是顯示容量為LBA:0 / 0MBb. BIOS抓不到硬碟如果你是a的情況這邊教學不適合你解決方式請看http://minchuanwang.blogspot.com/2009/03/seagate-720011-1bioslba0-0m-2bios.html如果你是b的情況,那就沒問題照著我的教學文章來看There are two common errors on Seagate 7200.11 HDDs (caused by bugs on firmware):- 0 LBA error: it happens when your BIOS can recognize your HDD at POST moment, but as an 0MB drive.- BSY error: it happens when your HDD enter on a halt state, or BuSY state. In this condition, your HDD will not be recognized by BIOS at POST moment.This article is BSY error fix only.事前確認步驟:鎖住的硬碟接上USB解鎖線硬碟接上電源(請用電源供應器提供的SATA電源線,而經過轉接插頭的SATA電源線)開啟超級終端機(XP內建)馬上顯示下列資料LED:000000CC FAddr:0024A051此時按下CTRL+Z都不會有任何命令列跑出來代表被鎖住了沒有出現這畫面的話代表你不是這種鎖住錯誤方式或者你的USB解鎖線的TX/RX接相反了這個步驟也算測試你的usb解鎖線有沒有成功連接我跑這個步驟時,usb解鎖線沒反應重新檢查後把usb解鎖線接駁的地方拆掉絕緣膠帶,重新接線通過確認,出現LED:000000CC FAddr:0024A051後我才開始進行正文解鎖Explanation: The problem with the drive is that the drive is stuck/halt in a BUSY state. This basically locks up the SATA port, causing the BIOS problem (cannot detect the drive at POST). In the terminal, you will see this sort of error (LED: 000000CC FAddr: 0024A051). Once you see this in the terminal, the terminal session to the drive is completely blocked and will not accept any more