UPDATE GUIDE Introduction: This update will fix a rare issue effecting some DAB radio stations. Update file JBL_TUNER2 is included in the .zip file attachment. Please follow the instructions to update your JBL TUNER 2: 1. Connect the USB cable that came with the Tuner 2 to the USB-C port on the JBL TUNER 2 and then connect it to your computer’s USB port. Please make sure you do not have other USB disks connected for a smooth update. 2. Turn on the JBL TUNER 2. 3. Press and hold the [DAB/FM] and [Volume –] buttons simultaneously for > 10 seconds, until you see the message on the display - “Connect to PC or Mac then copy update File”. 4. Open “This PC” on your PC, or “Finder” on your Mac and find the USB Drive under “Devices”, this is the Tuner 2. 5. Copy the file JBL_TUNER2 file that you have received with this document and paste it into “USB Drive”. 6. After copying the file, please right click on “USB Drive” and press “Eject”. The update will start automatically. The JBL TUNER will display “Updating”. The update process takes 5-10 seconds. 7. When finished the TUNER 2 will turn on again by itself. You can now disconnect the cable. NB: To check the installed software version: First select the language and perform a scan, then press and hold the [Preset 1] and [Preset 5] buttons simultaneously for > 10 seconds. The installed version will be shown on the top line of the display. If 0046 is shown, the installation was successful.