請問機車前輪胎會緩慢消風

buyd80 wrote:
輪胎打28PSI,...(恕刪)


可能輪框有傷或髒汙沒清乾淨 或者沒有上黃油再裝
下次框拆下來用菜瓜布把框邊整個清過一遍 檢查看看有沒有被橇胎棒挖過的痕跡 如果嚴重的話只能每次灌禍換框了

Stereophotography wrote:
可能輪框有傷或髒汙...(恕刪)

胎唇不建議抹黃油,有傷害橡膠的問題。若沒有專用安裝油,用肥皂水或是矽油都比黃油好。
群青的高空......朱色的殘照...... 飛舞而降臨的...白青之王者.... 紅色沙塵---- 白色的...火焰,光輝的
auxo wrote:
胎唇不建議抹黃油,...(恕刪)


喔 這我就要堅持一下了
塗黃油不但沒問題 油份被橡膠吸收後 皂基會變成填縫劑讓氣密度增加 不要塗太多就是了
小米也出了這種東西 我想就算不是最佳 也不至於不適用



Stereophotography wrote:
喔 這我就要堅持一...(恕刪)

https://www.michelintruck.com/michelintruck_en_us/assets/pdf/bulletins/TB_Lubricant_MX_Truck_Tires.pdf
小米這份文件寫的:
Never use antifreeze, gasoline, ether, silicones, or any petroleum based lubricants.

但我找不到這項產品的主成分敘述,只能猜小米不會做一個打自己臉的產品?

不過用黃油潤滑胎唇...我以前也這樣用過啦,只能說沒產生問題。不過照小米說的,矽油看來也不適用?
群青的高空......朱色的殘照...... 飛舞而降臨的...白青之王者.... 紅色沙塵---- 白色的...火焰,光輝的
auxo wrote:
https://www...(恕刪)


我倒是找到這個
Murphy's Tire and Tube Mounting Compound

Murphy's Tire and Tube Mounting Compound is designed to assist in mounting rubber tires and tubes on all types of wheels. It is fortified with rust inhibitors to provide protection against wheel corrosion. Murphy's mild formula is worker friendly.

Murphy's Tire and Tube Mounting Compound is a thick, vegetable based lubricant. Murphy's can be used in its concentrated form or diluted in water (3-4 parts water, 1 part Murphy's).

Environmentally friendly
Non-toxic, biodegradable
Totally safe for all tires
Made from natural, renewable resources
Economical when diluted
No petroleum oils of any kind
Ultra-thick concentrate for excellent performance when packing beads
Industry-Leading Quality and Performance

A difference you can see and smell, because we use only high-quality vegetable oil in the manufacture of Murphy's tire mounting lubricant, which is lighter, clearer, extremely consistent and does not separate.
Competitors' lesser quality formulas, made with cheap raw materials, are often darker, thicker, unpleasant smelling (for a reason), and separate out.

--------------------

確實 輪胎專用安裝油脂是不用礦物油成分 這邊用的是植物油為基底
謎底解開了 用沙拉油最好 今天又多學到一點
我想應該是因為卡車內胎需要整個內胎進行潤滑 用一般黃油就真的不好 高速胎只有唇邊我用是都沒什麼問題
因為這東西根本沒有給一般人用的包裝 我想我自己裝應該還是會用黃油

Philips0924 wrote:
前輪拆卸較易,整顆...(恕刪)

輪胎其實也不需要拆啊
拿個比較大的臉盆
前輪舉起來放到臉盆內..
立馬現形..
一樣沒有的話前輪舉起叫一個人轉動輪胎
泡臉盆才是抓漏正確的用法
Stereophotography wrote:
我倒是找到這個Murphy...(恕刪)

網拍上有日本 MARUNI 1KG 輪胎臘 ,價錢我覺得還可以。或也有賣家分裝WURTH 輪胎裝配劑,可以參考看看。
1kg的還有GO GOMMA,也不算貴。
不然就沙拉油沾一沾就好
群青的高空......朱色的殘照...... 飛舞而降臨的...白青之王者.... 紅色沙塵---- 白色的...火焰,光輝的

auxo wrote:
網拍上有日本 MARUNI...(恕刪)

一般自家裝輪胎
沒必要買那種專業胎蠟~太貴
去五金賣場買汽車內裝的噴蠟
一瓶特價5~60
一瓶可以讓你裝5~60條輪胎

跑龍套也要找些專業的 wrote:
一般自家裝輪胎沒必...(恕刪)

噴蠟也是含矽油,也是可以啦。前陣子都是直接用矽油膏,要多花點時間塗勻,但效果也不差。
群青的高空......朱色的殘照...... 飛舞而降臨的...白青之王者.... 紅色沙塵---- 白色的...火焰,光輝的
不過真要用矽油或噴蠟

我是覺得用補胎劑最好用
文章分享
評分
評分
複製連結

今日熱門文章 網友點擊推薦!