請問各位大內高手
小弟有台HX2750的機台
先前已經更新到WM6.0了
最近又想跟新到更新版本
想請問一下
我的步驟該如何去用
因為我有試著直接更新，
他會顯示錯誤訊息
可否提供一下
感謝告知
個人積分：316分
文章編號：5815795
個人積分：34分
文章編號：8838663
個人積分：5分
文章編號：8841397
個人積分：5分
文章編號：8841450
iPaq HX2110
USB connection to computer
1) Hard reset iPaq. Do this by holding the calendar button and itask button (curved arrow), and then put your stylus into the reset hole on the bottom of the iPaq. This will hard reset it.
2) After doing that, put it in to bootloader mode. You do this by holding the contact button (to the right of the calendar) and the itask arrow, and then clicking the reset button on the bottom. It should now be in bootloader mode. unplug the power/usb cable and plug it back in. hit the calendar button. it should now say USB.
3) run hpRUU.exe under the Wm5.0 for hx2000_1.00.00.L_ENG folder. It's found in provishki. it will flash your ipaq to 1.00.00.l . let it flash all the way.
4) hard reset the ipaq and put it in bootloader mode. see steps 1 and 2. make sure it says USB.
5) do step 3 again, but this time don't click upgrade. rename the E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf file to 100l.nbf
6) go into the SP32408_1.00.00.H_ENG folder and get the NBF file from there. copy it into the 1.00.00.L folder that we were just in. rename is to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf. click upgrade. let the upgrade finish.
7) repeat steps 1 and 2.
8) delete the E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf file that you just copied over and rename the 100l.nbf file to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf.
9) run hpruu.exe again. DO NOT CLICK UPGRADE.
10) get the wm6_wwe.nbf file and copy it into the directory we were just in. rename E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf to 100l.old and wm6_wwe.nbf to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf
11) click upgrade. let it finish.
12) repeat step 1
you should now have Windows Mobile 6 on your iPaq. Good luck
