小弟在官網下載了WM5的程式
依照官網方式去更新
但是畫面卻顯示無法更新
小弟是利用原廠USB線,小弟的2110是中文機
如果可以的話轉ENG都可以但請提供方法
個人積分：158分
文章編號：10589018
個人積分：5分
文章編號：10691627
2) After doing that, put it in to bootloader mode. You do this by holding the contact button (to the right of the calendar) and the itask arrow, and then clicking the reset button on the bottom. It should now be in bootloader mode. unplug the power/usb cable and plug it back in. hit the calendar button. it should now say USB.
3) run hpRUU.exe under the Wm5.0 for hx2000_1.00.00.L_ENG folder. It's found in provishki. it will flash your ipaq to 1.00.00.l . let it flash all the way.
4) hard reset the ipaq and put it in bootloader mode. see steps 1 and 2. make sure it says USB.
5) do step 3 again, but this time don't click upgrade. rename the E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf file to 100l.nbf
6) go into the SP32408_1.00.00.H_ENG folder and get the NBF file from there. copy it into the 1.00.00.L folder that we were just in. rename is to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf. click upgrade. let the upgrade finish.
7) repeat steps 1 and 2.
8) delete the E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf file that you just copied over and rename the 100l.nbf file to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf.
9) run hpruu.exe again. DO NOT CLICK UPGRADE.
10) get the wm6_wwe.nbf file and copy it into the directory we were just in. rename E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf to 100l.old and wm6_wwe.nbf to E1_Upgrade_ROM_v1_00_00_L_SIGNED.nbf
11) click upgrade. let it finish.
12) repeat step 1
雖然我是菜英文，可是我有成功!
