* Improved Courses to function off of location based logic. When doing a Course the user is now matched to a position along the Course based on location and heading. Allows users to join Courses at any point during their ride and have the Course synchronized to their position. * Changed to allow Autolap in Courses. * Show Compass page with guidance when doing a Course. * Add 'Distance to Next' and 'Time to Next' fields on the Compass page. * Disabled redundant Alerts during Workouts. * Keep GPS page in page loop if there is no GPS fix. * Allow editing of the position and elevation when marking a location. * Add ability to find nearest locations and to delete all. * Add ability to put GPS in Autolocate mode by holding DOWN when powering on. * Add quick settings lists to Quick Workout setup. * Add Warmup and Cooldown to Interval Training feature. * Seperated the distance and elevation units setup values. * Fix problem that could occur on workout lists from too many Workouts or Workout Steps. * Fix problem where calories would sometimes not reset after upload to Training Center. * Fix problem with distance not updating and track not recording if unit was powered down while plugged into USB, and then powered back on without ever being disconnected. * Fix problem with Autopause not working when set to 0 or stopped. * Fix problem with potential slowdown and lockup on Altimeter page. * Fix problem with reporting invalid cadence values when sensor not present. * Added support for nRoute. * Added Slovakian and Slovenian Languages. * Updated translations. * Fix problem where multiple cadence sensors not being stored off for separate bike profiles. * Power off USB pins when not connected.