Canon單眼相機 - EOS 5D Mark IV Firmware Version 1.0.4 牙膏廠再度發威...有夢最美 - 相機

前往內容


EOS 5D Mark IV Firmware Version 1.0.4 牙膏廠再度發威...有夢最美

https://www.usa.canon.com/internet/portal/us/home/support/details/cameras/dslr/eos-5d-mark-iv?subtab=downloads-firmware

All video output will still be 8-bit.
Sampling for DCI 4K will be increased to a 5632 x 2970 pixel sensor area resulting in a 1.27x Crop factor.
Sampling for UHD will be from a 5472 x 3078 pixel sensor area resulting in a 1.29x Crop factor.
Both modes are accurately down-sampled to their final resolutions.
Existing frame rates will remain the same.
The current 1:1 4K sampling mode will remain an option for situations benefiting from the 1.78x Crop factor.
There will also be new full-sensor 3K modes added including 60fps and HDR 24fps.[…]
FullHD 1080p will also use this 3K full-sensor mode with down-sampling for a noticeable improvement in perceived resolution.
FullHD 1080p will also receive a modest frame rate boost to 72/75fps.
The EOS 5D Mark IV will gain the XF-AFC file format at 120Mbps (4:2:0) and 200Mbps (4:2:2). Both formats should require low enough data rates to accommodate UHS-I U3 type SD Cards.
Reports relating to a possible service job for the 5D Mark IV are the result of the heat sinks on current units not performing well in some environments when used with the newer firmware. […]
The newer firmware will still work in non-serviced cameras, but this may result in premature temperature warnings.

牙膏廠再度發威
每次都There will also be

最後再補上這句:Reports relating to a possible service job for the 5D Mark IV are the result of the heat sinks on current units not performing well in some environments when used with the newer firmware

放出來試水溫看銷量有無增加....

韌體要更新就更新阿.
hcy101 wrote:
EOS 5D Mark IV Firmware Version 1.0.4


可是這個更新並沒有像寫得那樣

有更新4K那些的

只有更新一些些小BUG而已啊


固件版本1.0.4中的更改包含以下修復和改進:


1.修復在以燈泡模式拍攝或長時間曝光時拍攝圖像的底部中心可能會出現紅色區域的現象。
2.當在自定義控制菜單中配置時,通過按快門按鈕,AF-ON按鈕或AE鎖定按鈕啟動自動對焦時,自動對焦可能無法響應的現象。
3.增強攝像頭與SD卡之間通訊的可靠性。
4.在芬蘭語菜單屏幕上修正不正確的措辭。
1.04只有跟新這些

1. Fixes a phenomenon in which a red-colored area may appear at the bottom-center of a captured image when shooting in bulb mode or during a long exposure.
2. Fixes a phenomenon in which the autofocus may not respond when the autofocus is initiated via pressing the shutter button, the AF-ON button or the AE lock button when configured in the custom control menu.
3. Enhances the reliability of communications between the camera and SD card.
4. Fixes incorrect wording on the Finnish language menu screen

1頁 (共1頁)

前往




此文章的引用連結