請教各位大大:

我用美光m4(128g)作桌機開機碟,昨晚關機時跳出系統更新中,結果一直都沒有自動關機(似乎卡在那),我就用強迫關機,結果....
重開機時連bios都抓不到,換到別的機器也找不到(安裝失敗),
爬了一下文,似乎ssd對強制關機或突然斷電很傷,但是,遇到這種「系統卡住關不掉」的情況,該如何處理?
還是單粹只是好人卡收集太少,該掛就掛了(還好資料沒有很多)

還請各位高手給予提示,以免又一次遇到(已請0800來取件,桌機要停用一周了)

謝謝各位
文章關鍵字
dadali wrote:
請教各位大大:我用美...(恕刪)


韌體是010G嗎? 這版韌體感覺不是很穩
建議升級到040H 我使用過後覺得還蠻穩定的

我用010G韌體時也發生過你說的這種情形
送修前其實可以嘗試把m4重設power cycle
Micron/Crucial 技術人員有說重設Power Cycle就能再偵測到m4
1) m4 SSD只插電源線(不插SATA線) 開機後閒置20分鐘 建議閒置不要使用電腦
2) 關機然後m4 SSD電源拔起30秒
3) 再重複步驟1-2最少一次
4) 把SATA線插回 正常開機 m4 SSD應該就能偵測到了

原文如下
"In most cases, your SSD can be returned to normal operating condition by completing a power cycle. The process will take approximately one hour.

We recommend you perform this procedure on a desktop computer because it allows you to only connect the SATA power connection, which improves the odds of the power cycle being successful. However, a USB enclosure with an external power source will also work. Apple and Windows desktop users follow the same steps.

1. Once you have the drive connected and sitting idle, simply power on the computer and wait for 20 minutes. We recommend that you don't use the computer during this process.

2. Power the computer down and disconnect the drive for 30 seconds.

3. Repeat steps 1 and 2 at least one more time.

4. Reconnect the drive normally, and boot the computer to your operating system.

5. If the latest firmware has not been updated to your drive, do so. Go to Crucial.com Product Downloads - Firmware Updates for our firmware updates.

A laptop computer will also work, but you’ll have connect the drive and navigate to the systems BIOS menu. (Please refer to your system manufacture’s documentation on how to access the BIOS.) Allowing the drive to sit in the BIOS will improve the odds that the power cycle will work. For laptops, we don’t recommended using a USB enclosure powered via USB. In addition, Apple users must hold the Option key while they power on the system (with the SSD installed). This will boot the Mac to the Startup Manager screen. The Startup Manager screen works like the BIOS screen on a laptop, in that it gives the drive power without any data throughput.

1. Laptop users will need to be in the BIOS menu, or Mac Startup Manager as stated above. The computer will need to stay powered for 20 minutes. We recommend you don’t use the laptop during this process.

2. Power the computer down and disconnect the drive for 30 seconds.

3. Repeat steps 1 and 2 one more time.

4. Reconnect the drive normally, and boot the computer to your operating system.

5. If the latest firmware is has not been updated to your drive, do so. Go to Crucial.com Product Downloads - Firmware Updates for our firmware updates."
剛查了一下,大陸流行三十分鐘通電修復法,就是將SSD拆下接到別台電腦,只接電源線就好,電腦開機的情形下,通電三十分鐘,關機,接回原電腦即可.也有人只直接重刷降級或升級軟體版本就可以直接恢復.
恭喜,我的m4也碰到

我的m4是裝在PS3裡的,要是PS3沒回到XMB後才關而是遊戲直接退出就會發生這悲劇

那時的版本是000F,現在升到040H但沒勇氣嘗試問題解決沒..........

碰到這問題解決辦法是得準備約半小時去不斷的重複開關機給他抓,最終會恢復能抓到.....

有點後悔當時沒加錢買普傑的
昨天碰到朋友的Intel 330也是強制關機重開後SSD出現問題

幾次的重覆開關機才正常運作

*這是SSD的bug還是?...
很關注此篇啊,是不是入手SSD的時代還沒有來到呢?.....
小弟不安全關機次數已經累積到127次了....
前一陣子調CPU參數動不動就當機

不過非美光SSD

hugetrader wrote:
很關注此篇啊,是不是...(恕刪)


還好吧 我家電腦跟筆電共8台都換SSD了
Intel 510 520 美光m4都有用
偵測不到SSD一年多來只發生過兩次
只要正常關機就不會發生
不正常關機也不是每次都會這樣
只是有機率會發生而已
感謝大家的回應

特別有位大大提及的接電修復,因為怕後續有後遺症(畢竟這顆ssd買不到一個月),所以還是先叫0800來取件送回,待新的一顆回來後,再看韌體是否是最新的

目前已先將原先的intel 520換上(因這顆只有80g,灌完系統只剩7g)(這顆之前也曾不安全關機數次,卻無問題)

看來ssd還是盡量以系統碟為主,不要放太多資料(特別是重要的資料),以免哭都來不及

再次感謝大家,也特別注意到應該要多多作好備份

我以前也很常碰到
但最近就沒再碰過了

修復方法也可以先開機到BIOS 等個十分鐘 關機 再開 也會正常
文章分享
評分
評分
複製連結

今日熱門文章 網友點擊推薦!